If your bake operation on your gas oven is not functioning properly chances are good you have a bad ignitor. This is a step by step guide on how to properly setup a new oven ignitor.
There is a wide collection of oven brands and designs vary considerably from one oven to another. Allowable care should be taken to inventory for the differences between the body styles of ovens such as Whirlpool, Kenmore, Ge, Frigidaire, Lg, and others. The procedures are very similar any way give Allowable attentiveness to information to get the job done properly.
Ignitors are man-made in round or flat (rectangular) designs depending on the oven model. Do not mix the two. If you have a round ignitor, replace it with a round one. If you have a flat ignitor, replace it with a flat one. If you are unsure of which ignitor to use than regain a parts diagram for your exact oven and regain the Allowable part number.
On most brands you can access the inner oven area without removing the door. If you would like to take off doors for ease of access then effect the manufacturer's policy for removing the door. On most Ge models, open the door partly and gently pull up on door to slide off the hinges. On Whirlpool and KitchenAid type ovens open the door to the full open position, lower hinge clips - see goods hand-operated for location -, close the door partly and slide the door off the hinges.
The inside bottom panel of the oven cavity will need to be removed. take off thumbscrews at the back of the bottom panel. Grasp the back of the panel straight through vent openings and pull away and up to take off panel. This will expose the ignitor.
Remove the lower drawer to gain access to ignitor wire terminals. Disconnect the ignitor wires from valve and wire harness.
Remove the burner assembly. There should be one screw holding the front of the burner to front inside oven. With the drawer removed, uncover the other screws securing the lower part of burner tube and take off the burner tube.
Remove the two screws securing the ignitor and setup the new ignitor. A beneficial recipe of removing the two oxidized screws is to put a dab of liquid soap on each of the threads before removing the ignitor.
The plug and final ends of the old ignitors must be reused. Cut both ends 3-4 inches long and splice to the new ignitor wires using ceramics wire nuts.
Feed the wires back straight through the rear of the occasion and reinstall the burner tube.
Plug the two wires back in and tuck the excess wiring behind paneling or gas tubing. Replace the bottom panel of oven.
The above policy will work on most domestic models of ovens and ranges. It will usually take about 1 hour to achieve this job.
Oven Ignitor fix
No comments:
Post a Comment